ZyXEL Communications Prestige 794M - Manual (Page 25)

Prestige 794M User’s Guide
25 Chapter 1 Introduction
1.5 Rear Panel
The following figure shows the rear panel of the Prestige.
Figure 6 Rear Panel
The following table describes the ports.
LAN 1..4 Orange On The Prestige has a successful 10Mbps Ethernet connection.
Flashing The 10M LAN is sending or receiving packets.
Green On The Prestige has a successful 100Mbps Ethernet connection.
Flashing The 100M LAN is sending or receiving packets.
Off The LAN is not connected.
LINE 1, 2 Green On The Prestige has a successful SHDSL link.
Off The SHDSL link is down or not connected.
Table 1 Front Panel: LEDs (continued)
LED COLOR STATUS DESCRIPTION
Table 2 Rear Panel
LABEL DESCRIPTION
LAN 1..4
(RJ-45 connector) Connect a computer to this port with an Ethernet cable. This port is auto-
negotiating (can connect at 10 or 100Mbps) and auto-crossover (automatically
adjust to straight-through or crossover Ethernet cable).
CONSOLE Only connect this port if you want to configure the Prestige via console port.
Connect one end of the console cable to the console port of the Prestige and the
other end to a serial port (COM1, COM2 or other COM port) on your computer.
Your computer should have a terminal emulation communications program (such
as HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits, 1 stop
bit, no flow control and 9600 bps port speed.
LINE 1..2 Connect to a telephone jack using the included telephone cable.
RESET You only need to use this button if you’ve forgotten the Prestige’s password. It
returns the Prestige to the factory defaults.
Press this button is for less than three seconds to restart the Prestige.
Press this button in for more than six seconds to reset the Prestige to the factory
default settings.
PWR Connect to a power source using only the included power adaptor for your region.
Power Switch After you’ve made the connections and connect the power adaptor to a power
supply, push in the power button to turn on the Prestige.