ZyXEL Communications Prestige 794M - Manual (Page 42)

Prestige 794M User’s Guide
Chapter 3 LAN 42
The following table describes the labels in this screen.
3.5 Port Setting
Use the Port Setting screen to configure the LAN port settings on the Prestige. Click
Configuration, LAN and Port Setting to display the screen as shown next.
Figure 23 LAN: Port Setting
The following table describes the labels in this screen.
Table 15 LAN: Ethernet Client Filter: Active PC in LAN
LABEL DESCRIPTION
IP Address This field displays the IP address of an Ethernet device connected to the Prestige.
MAC Address This field displays the MAC address associated with the IP address in the IP
Address field.
Add Click Add to add the select entry(ies) in the Ethernet Client Filter screen.
Table 16 LAN: Port Setting
LABEL DESCRIPTION
Port 1 .. 4
Connection
Type
Select the speed and the duplex mode of the Ethernet connection on this port.
Choices are Auto, 10Mfalfduplex, 10Mfullduplex, 100Mhalfduplex and
100Mfullduplex.
Selecting Auto (auto-negotiation) allows one port to negotiate with a peer port
automatically to obtain the connection speed and duplex mode that both ends support.
When auto-negotiation is turned on, a port on the Prestige negotiates with the peer
automatically to determine the connection speed and duplex mode. If the peer port
does not support auto-negotiation or turns off this feature, the Prestige determines the
connection speed by detecting the signal on the cable and using half duplex mode.
When the Prestige’s auto-negotiation is turned off, a port uses the pre-configured
speed and duplex mode when making a connection, thus requiring you to make sure
that the settings of the peer port are the same in order to connect.
IPv4 TOS
Priority Control
Select Enable to set the Prestige to send traffic based on the priority level.
Select Disable to set the Prestige to treat all traffic equally.