ZyXEL Communications Prestige 643 - Manual (Page 76)

Prestige 643 ADSL Router
5-4 Remote Node TCP/IP Configuration
.
Figure 5-4 Sample IP Addresses for a TCPI/IP LAN-to-LAN Connection
To configure the TCP/IP parameters of a remote node, first configure the three fields in Menu 11.1 –
Remote Node Profile, as shown in the table below.
Table 5-1 TCP/IP-Related Fields in Remote Node Profile
FIELD DESCRIPTION EXAMPLE
Route Make sure IP is among the protocols in the Route field in Menu 11.1 –
Remote Node Profile. IP
Rem IP
Address Enter the IP address of the remote gateway in Menu 11.1 – Remote
Node Profile. You must fill in either the remote Prestige WAN IP address
or the remote Prestige LAN IP address. This depends on the remote
router’s WAN IP, eg. for the (remote) Prestige, the My WAN Addr settings
in Menu 11.3. For example (see previous Figure), if the remote WAN IP
is set to 172.16.0.2 (the remote router’s WAN IP), then you should enter
172.16.0.2 in the Rem IP Addr field. If the remote WAN IP is 0.0.0.0,
then enter 192.168.1.1(the remote router’s LAN IP) in the Rem IP Addr
field.
Edit IP Choose Yes and press [ ENTER ] to view Menu 11.3 – Remote Node
Network Layer Options.
No