ZyXEL Communications Prestige 643 - Manual (Page 86)

Prestige 643 ADSL Router
6-4 IPX Configuration
6.2.1 Prestige 643 on LAN With Server
If your Prestige is on a LAN with a seed router, you do not need to configure the LAN network numbers.
Your Prestige will learn the network number from the seed router and add the routes to its routing table.
6.2.2 Prestige 643 on LAN Without Server
Each IPX network must have a seed router. If you only have NetWare clients on your network, then you
must configure the Prestige as a seed router and set up unique network numbers for each frame type enabled
using Ethernet Setup menu.
6.3 IPX Ethernet Setup
In Menu 3 – Ethernet Setup, press 3 to display Menu 3.3 - Novell IPX Ethernet Setup as shown next.
Figure 6-3 Menu 3.3 - Novell IPX Ethernet Setup
The following describes the Novell IPX Ethernet Setup menu.
Menu 3.3 - Novell IPX Ethernet Setup
Seed Router= No
Frame Type 802.2= Yes
IPX Network #= N/A
Frame Type 802.3= No
IPX Network #= N/A
Frame Type Ethernet II= No
IPX Network #= N/A
Frame Type SNAP= No
IPX Network #= N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.