Z Microsystems GLIDER 20 - Manual (Page 12)

Doc# 27-0006UM Issued 11/00 Rev 1.0
VERY IMPORTANT.
Hold the top of the
display in the vertical
position while rotating
the latch clockwise to
the locked position.
Push down on the latch
at the base of the
display. Then lift the
raised latch from its
receptical to the
unlatched position.
Rotate the latch counter-
clockwise to unlock the
latch.
Holding the base with
one hand, lift the back
of the pivioted display
up to the vertical
position.
With both hands, press
both the Z-Locks down.
SETTING UP GLIDER
Slide the Glider all the
way out to the safety
stop.
12
Once the display is
locked in position,
lower the latch back
into the base recepticle.
Setup
Lift and slide the two
display lock knobs at the
back of the display to the
open or inward positions.
This allows the display
top to be lifted from its
storage position.
The outer Z-lock bracket
fits snuggly against the
female Z-lock bracket
attached to the cabinet
frame.