Z Microsystems GLIDER 20 - Manual (Page 7)

Doc# 27-0006UM Issued 11/00 Rev 1.0
SLIDE REMOVAL
With the Glider laid on
a workbench, press
down to release the Z-
Locks on each side of
the front of the Glider to
slide the side rails back.
The slide rails will reach
a stop about half way
back.
This is a safety stop to
prevent the Glider from
sliding out too far while
mounted in the rack.
Simultaneously press in
the safety catches on
each slide rail and slide
the side rails all the way
off the back of the
Glider.
The slides should now
be separated from the
Glider.
7
Install Slides