Z Microsystems GLIDER 20 - Manual (Page 6)

Doc# 27-0006UM Issued 11/00 Rev 1.0
TOOLS REQUIRED
PRECAUTIONS
Required Tools and Equipment.
• Flathead screwdriver with about
10" shaft.
• Phillips screwdriver with about 10"
shaft.
• Adjustable wrench or box
wrenches.
In preparation to install the Glider,
take the following precautionary
steps:
• Turn off the electrical power to your
computer.
• Verify the Glider power switch is
off. If the Glider is off, the Power
light on the display front will not be
illuminated and the power switch
will be down toward the straight
line.
WARNING: To avoid shock hazard:
• Do not remove the covers
around the Glider.
• Do not connect or disconnect
the Glider during an
electrical storm.
• The power cord plug must be
connected to a properly
wired and grounded power
outlet.
• Any equipment to which the
Glider will be attached
must also be connected to
properly wired and
grounded power outlets.
• The socket outlet shall be
installed near the
equipment and shall be
easily accessible.
NOTE: For the fastest and easiest
installation of the Glider,
follow these steps in the
sequence they are
presented.
6
Starting Point