Z Microsystems GLIDER 20 - Manual (Page 23)

Doc# 27-0006UM Issued 11/00 Rev 1.0
23
To adjust the screen for the best
possible display, try the following:
• Press the and buttons
until you have a universally fuzzy
screen.
• Count the number of button
presses for the screen to go from
fuzzy to clear to fuzzy again.
• Divide the number of presses by
two and press the button that
many times to precisely end up at
the clearest setting.
• The clearest setting may also be
verified by visually monitoring the
screen while adjusting the settings.
Step 6: Adjust Brightness
If the brightness adjustment is made
to maximize the display visibility, press
the “SELECT” button until the “Brt”
indicator is illuminated, then use the
and buttons to increase/
decrease the display brightness. The
factory default setting is maximum
brightness.
NOTE: If at this point the screen
image is not crisp, repeat
Steps 2-4.
Step 7: Saving Adjustments
The screen settings will automatically
be saved as long as the power is
maintained for at least five seconds
after the last adjustment.
NOTE: See “Saving Settings” earlier
in this manual for a
complete discussion of this
subject.