Z Microsystems GLIDER 20 - Manual (Page 26)

Doc# 27-0006UM Issued 11/00 Rev 1.0
CLOSE GLIDER
Display Stowage
Tilt the display head
back towards the rear of
the rack all the way to
the horizontal position.
2 6
The following describes closing and stowage of the Glider in the cabinet.
From the landscape
position, rotate the
display to the vertical
position.
VERY IMPORTANT
Hold the top of the
display while rotating
the pivot latch. Lift up
the display pivot latch.
Rotate the display pivot
latch counter-clockwise
to release the side lock
linkage.
Lower the display into
the Glider frame tray.
Rotate the display latch
clockwise to engage the
side lock linkage.
The display latch has
now locked the side
linkage.
Pull the Glider all the
way out to the stop. Tilt
the display head back.
Make sure there is
enough room to lower
the top of the display
head without hitting the
cabinet.