Acroprint ES1000 Totalizing Payroll Recorder - Manual (Page 29)

Selection #2 Punch Rounding is recommended.
Push the [SETTING START/END] button before you start setting. At that moment,
" " is shown on a display and you go into setting mode.
Example Type of rounding is "Punch". Rounding unit is "15 minutes".
Selecting Rounding Rules
1
Push the [FUNCTION ] button for 2
seconds.
3
In case of the example, push the [+]
or [-] button to set the left-side
number at "2" to select "punch time
rounding" and then push the [SET]
button. At that moment, flashing of
the display will change from "Type
of Ronuding" to "Rounding Unit".
2
Once a number on the display starts
flashing, position the " " mark
under the "ROUND" mark by
pressing [FUNCTION] button.
A flashing number can be changed.
29
SET FUNCTION
ROUND
SET FUNCTION
ROUND
[TYPE]
1 Hours
2 Punch
[UNIT]
1 None
2 6 minutes
3 10 minutes
4 15 minutes
For "Rounding", there're 2 settings: "Types of Rounding" and "Rounding Unit". For "Types
of Rounding", there're "Hours Rounding" and "Punch Time Rounding", and you can choose
one.
For "Hours Rounding", the recorder calculates the hours from "IN" punch to "OUT" punch,
and then, rounds that result with the "Rounding Unit" that you have selected.
For "Punch Time Rounding", the recorder rounds both time of "IN" and "OUT" punches, and
then, calculates the hours from the time "IN" to "OUT". (Recommended)
Breakpoint means the point where it will raise or omit fractions.
23