EVS XS Version 11.02 - July 2013 Configuration Manual - Manual (Page 169)

3.8.3. Tally Settings
Introduction
The Tally settings allow specifying the settings related to the tally feature. This feature
allows the user to automatically create a clip for each change of camera performed with
the Director’s Cut and to add these clips to a playlist. The clips are created automatically
by the server as it receives GPIs IN signals from a switcher when the director changes
the camera angle.
User Interface
These fields are available in the following interfaces:
• in the Multicam Configuration window, GPI tab
• in the Technical menu of the Remote Control Panel (T6.X)
The following screenshot presents the settings page of the Monitoring tab in the server-
based application and highlights the Tally settings area.
How to Activate the Tally Function
To use the tally function, proceed as follows:
1. Activate it using the Tally parameter.
2. Go to the GPIs IN settings area and select the GPI IN used for the tally control.
3. Set the Channel/Device on the REC on which the Director’s Cut is performed.
4. Set the function as Mark Tly.
CONFIGURATION MANUAL XS Server 11.02
3. Multicam Configuration 161