VEGA TH LINK Version 1.1 Installation Guide - Manual (Page 13)

Start-up guideline
TH LINK | Trebing & Himstedt Prozeßautomation GmbH & Co. KG
13
Start-up guideline
The following steps are required for start-up:
1. Install the TH LINK (see "Installing the TH LINK" on
page 14).
2. Connect to Ethernet (see "Connecting to Ethernet" on
page 15).
3. Connect to the power supply (see "Connecting the power
supply" on page 16)
4. Configure Ethernet (see "Configuring the TH LINK in the
Ethernet network" on page 18)
5. Connect the PROFIBUS (see "Connecting the PROFIBUS"
on page 28).
6. If you use the TH LINK as a class 2 master you have to
configure PROFIBUS parameters of the TH LINK using an
application software (see "Setting PROFIBUS parameters"
on page 30).
Note regarding the application software
For operating the TH LINK as a class 2 master, an application
software with the appropriate drivers is required. For more
information about purchasing and operating the software please
check our website at http://www.t-h.de or contact our sales
department ([email protected]).
Note!
To set the IP address manually you must
connect your PC/notebook to the TH LINK via
crossover cable.