VEGA TH LINK Version 1.1 Installation Guide - Manual (Page 17)

Connecting the power supply
TH LINK | Trebing & Himstedt Prozeßautomation GmbH & Co. KG
17
Fig. 3: Terminal strip for power supply on the TH LINK
1. Connect the cable of a 24 V power supply and the earth
conductor (earth terminal) to the terminal strip on the device.
The terminal strip can be plugged and lifted out for
installation using a screwdriver.
2. Switch on the power supply. The LED RUN is green and the
LED ETH flashes red until the TH LINK's initiation procedure
is completed. Afterwards only the LED RUN lights green.
+24 V not assigned 0 V Earth conductor