Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA For use with EconoMind Ford (03-09), Chevy(01-08), Dodge (03-07) - Manual (Page 10)

10
96803 v.7.0
permanent hole in the dashboard
panel. Be certain of the location
of the docking station before
installing the screw.
Note: The docking station must be
connected to the previously installed
Banks PowerPDA-compatible EconoMind
Tuner via a RJ12 cable (simular to
telephone connector). If your EconoMind
Tuner is not installed, refer to the
EconoMind Tuner owner’s manual to
install the Tuner before proceeding.
17.
Remove the fuse access panel
below the steering column. It is
secured by four 1 ⁄
4
-turn plastic screws.
18.
Remove the smaller dash panel
immediately to the right as shown in
Figures 18 and 19. Unclip it by pulling
in the area shown in the picture.
19.
Locate the RJ12 cable from
your EconoMind Wiring harness and
route it to the bottom of the docking
station behind the panels you’ve just
removed.
Figure 13 Dodge (‘03-’05)
Figure 14 Dodge (‘03-’05)