Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA For use with EconoMind Ford (03-09), Chevy(01-08), Dodge (03-07) - Manual (Page 26)

Checking for Engine Diagnostic
Codes:
1.
Press the center button on the
5-way navigator to take you the
System Menu screen.
2.
Next, touch the ‘OBD II’ button.
3.
With the ignition in the on/run
position or with the engine running,
touch the button labeled ‘check For
codes’. See Figure 43.
Note: On Dodge vehicles and
motorhomes, the ignition key must be
in the On/Run position, but the engine
must NOT be running. If the engine is
running, Banks PowerPDA will display
a pop-up message instructing you to
check the ignition key is in the ON
position.
The Banks PowerPDA will check
for vehicle diagnostic codes and
display either the error code with a
brief description of the code or the
message “Done! – No codes Present”.
For a full description of the code,
highlight the code and a window will
pop up with a detailed explanation.
4.
To return to the System Menu
touch ‘<Back’. If diagnostics were
found and you would like to clear
them, proceed to step 5.
Clearing Engine Diagnostic Codes:
5.
After checking for and reviewing
any diagnostic codes, touch ‘clear
codes’ to erase them from the vehicle
PcM. If multiple codes are present,
they will all be cleared.
Note: On Dodge vehicles and
motorhomes, the ignition key must be
in the On/Run position, but the engine
must NOT be running. If the engine is
running, Banks PowerPDA will display
a pop-up message instructing you to
check the ignition key is in the ON
position.
6.
Press ’check For codes’ again to
verify the engine codes were erased.
Some status monitor codes require a
certain amount of engine “run time”
in order to be cleared (i.e. P1000 on
Ford).
7.
If diagnostic codes re-occur on
your vehicle, you should investigate
the underlying problem to correct it.
-END SEcTION 11-
Section 11
ChECKING AND CLEArING ENGINE DIAGNoSTIC CoDES
Figure 43
26
96803 v.7.0