Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA For use with EconoMind Ford (03-09), Chevy(01-08), Dodge (03-07) - Manual (Page 21)

Section 8
SySTEM MoNITorS
The default System Monitor screen
displays the following: Gauges G1,
G2, G3, G4, Power level, Status
Indicator, Hist-O-Graph and a Status
Window. See Figure 33. The top
two gauge displays (G1 and G2) are
EGT and BOOST, which cannot be
changed. The bottom two gauges (G3
and G4) can be changed to display
the available ‘Parameters’. Refer to
Section 9 for instructions on changing
the G3 and G4 gauge displays. The
selectable power levels are 1 thru
6. (Refer to Section 5-Changing
Power Levels). Below the Power
Level Indicator is the Status Indicator.
When communications are established
between the Banks PowerPDA ,
EconoMind Tuner and vehicle PcM
(Power control Module) then an ’OK’
will be displayed. In the event that
an on-screen alert or EconoMind
malfunction is triggered, the indicator
will show an icon relative to the alert.
The lower half of the screen displays
a Hist-O-Graph, which displays a
continuous graph of EGT and boost
readings. ‘Hist-O-Graph’ is the name of
the default System Monitor screen.
GAUGE G1
GAUGE G2
GAUGE G3
GAUGE G4
HIST-O-GRAPH
EGT(˚F)
POWER LEVEL
INDICATOR
STATUS INDICATOR
BOOST(PSI)
STATUS WINDOW
Figure 33
96803 v.7.0
21