Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA For use with EconoMind Ford (03-09), Chevy(01-08), Dodge (03-07) User Manual
Page 17
96803 v.7.0
17
and the rJ12 connector is
plugged into the docking station.
Although this charging cable is
short and its circuitry is fuse
protected, the user is expected
to take appropriate measures
to prevent small children and/or
pets from contact with any part
of this system.
38.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
39.
Double check everything to make
sure it is securely fastened and it
is not near any hot or moving parts
before starting engine.
40.
Set up the Banks PowerPDA
according to it’s instructions.
WArNING: The PDA may be
susceptible to damage as a
result of extended exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the PDA be removed from
its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage to
PDA’s resulting from exposure
conditions.
-END SEcTION 3-
With the key in the ‘ON’ position,
turn the Banks PowerPDA on and
click on the “Banks” icon (Figure
25). The Banks PowerPDA software
will initialize and the System Monitor
screen will appear (Figure 26). The
default System Monitor screen shows
the following: four Gauges, Power
Level, EconoMind Tuner Status,
Hist-O-Graph and a status window.
The System Monitor is the Banks
PowerPDA’s main screen.
-END SEcTION 4-
Section 4
SoFTWArE INTroDuCTIoN
Figure 25
Figure 26