Icon, Economind tuner – Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA For use with EconoMind Ford (03-09), Chevy(01-08), Dodge (03-07) User Manual

Page 33

Advertising
background image

96803 v.7.0

33

check for any damage to the

OBD II diagnostic connector

“hood”, such as if it has

become dislodged from the red

connector housing.

iv. Motorhomes: check the

connection at the diagnostic

port located near the engine

compartment. Make sure it

securely connected and locked.

e. check the EconoMind Tuner’s

power connection and fuse (refer

to the EconoMind Tuner user’s

manual for troubleshooting details).

2.

Loss of Tuner-added power (fueling)

a. check to make sure the Banks

PowerPDA’s Status Window

is displaying “connected to

Banks EconoMind”, indicating

the Tuner is powered-up and

communicating properly to the

Banks PowerPDA/docking station.

If the Status Window is displaying

“SEARcHING… For Banks

EconoMind”, the Tuner may not

have power. check the EconoMind

Tuner’s power connection and

fuse (refer to the EconoMind Tuner

user’s manual for troubleshooting

details).

b. check the Banks PowerPDA’s

Power Level Indicator for the

proper setting (Power Level “1” is

stock vehicle power).

c. check the Banks PowerPDA’s

Status Indicator for the “OK” icon.

Any EconoMind Tuner fault will be

indicated by the “Banks Engine”

icon (Figure 61) and its cause

can be investigated by going to

the ‘Self Diagnostics’ screen and

scrolling through the list of logged

Tuner events.

d. check for vehicle engine diagnostic

codes by going to the Banks

PowerPDA’s ‘OBDII codes’ screen

and touching ‘check for codes’.

If any diagnostic codes are

present, troubleshoot/repair the

cause. Once the cause is properly

remedied, touch ‘clear codes’

and then ‘check for codes’ again

to verify the problem is fixed (the

engine code should not re-appear).

e. Re-verify the ‘EconoMind Tuning’

parameters to make sure the loss

of added fueling is not caused

by improper settings of these

parameters. Pressing ‘Restore All’

will set the EconoMind Tuner back

to factory defaults.

f. Refer to the EconoMind Tuner

user’s manual for further

troubleshooting details.

-END SEcTION 16-

ECONOMIND TUNER

Figure 56

ICON

Advertising