Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA For use with EconoMind Ford (03-09), Chevy(01-08), Dodge (03-07) - Manual (Page 14)

22.
your docking station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the docking station.
Be sure the Banks PowerPDA is
completely seated in the docking
station against the lower support
bracket.
Note: There may be a snug fit when
installing the Banks PowerPDA into
the docking station. Take care not to
force this process.
23.
Plug the docking station’s
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA.
-(Ford 03-04) Skip to Section 4
ForD (’05-’07):
Note: The docking station must
be connected to the previously
installed Banks PowerPDA-compatible
EconoMind Tuner via a RJ12 cable. If
your EconoMind Tuner is not installed,
refer to the EconoMind Tuner owner’s
manual to install the Tuner before
proceeding.
24.
Remove the fuse access panel
below the steering column by pulling
on it with the handles as shown in
Figure 21.
25.
Remove the smaller dash panel
immediately to the right as shown in
Figure 22. Unclip it by pulling in the
area shown in the picture.
26.
Locate the RJ12 cable from
your EconoMind wiring harness and
route it to the bottom of the docking
station behind the panels you’ve just
removed.
27.
connect the RJ12 cable to the
left- most receptacle on the bottom of
the docking station.
Warning: The charging cable on
the docking station is designed
to supply a constant low-voltage
power source (+5VDC) to the Banks
PowerPDA and is “live” as long
14
96803 v.7.0
Figure 22 Ford (’05-’07)