Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA For use with EconoMind Ford (03-09), Chevy(01-08), Dodge (03-07) - Manual (Page 27)

Not available for motorhomes.
Note: For the Banks PowerPDA to do
performance testing, Gauge G3 or G4
must be set to monitor MPH. Refer to
section 10 to change Gauge G3 or G4
to read MPH. If a performance test is
selected without either gauge G3 or
G4 displaying MPH, a pop-up window
will appear.
For any of the performance tests to
be accurate, the vehicle must not be
moving at the start of the test. The
recommended method of setting up a
‘Performance Test’ is as follows:
a. Engine on, Banks PowerPDA on,
transmission gear in park.
b. Foot firmly on brake, select drive
gear.
c. Select the desired ‘Performance
Test’.
d. Banks PowerPDA is armed and
ready for testing .
e. Test begins once vehicle motion is
detected.
Setting up for Performance Testing
1.
Press the center button on the
5-way navigator to take you the
System Menu screen.
2.
Next, touch the ‘Perf. Tests’ button.
3.
Select the desired performance test
by touching the appropriate button.
The three tests to choose from are:
1 ⁄
8
mile ET, 1 ⁄
4
mile ET, and 0-60 MPH Test
(Figure 44).
Note: After selecting the desired test,
the Banks PowerPDA will immediately
arm itself and wait for vehicle motion
to begin recording. To ensure accuracy,
the vehicle should be completely
stopped when selecting the test.
Section 12
PErForMANCE TESTING
Figure 45
Figure 44
Figure 46
96803 v.7.0
27