Installing a rear i/o module – Cobalt Digital COMPASS 9322 HD_SD De-Embedder User Manual
Page 34
2
Installing a Rear I/O Module
2-4
9323 GROUP PRODUCT MANUAL
9323G-OM (V4.6)
Installing a Rear I/O Module
Note:
This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the card is to be installed.
If installing the card in a 8310-C-BNC or 8310-BNC frame (which is
pre-equipped with a 100-BNC rear I/O module installed across the entire
backplane) or a slot already equipped with a suitable I/O module, omit this
procedure.
The full assortment of Rear I/O Modules is shown and described in 923X
Group Rear I/O Modules (p. 2-5). Install a Rear I/O Module as follows:
1.
On the frame, determine the slot in which the card is to be installed.
2.
In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-2.
Figure 2-2 Rear I/O Module Installation
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
Note: Rear I/O Modules with -C, -D, and -E suffixes occupy two
rear module slot mounting locations and use two captive
screws.
Rear I/O Module with -G suffix occupies three rear module
slot mounting locations and uses three captive screws.
1
2