923x group rear i/o modules -5, Installation and setup – Cobalt Digital COMPASS 9322 HD_SD De-Embedder User Manual
Page 35
9323G-OM (V4.6)
9323 GROUP PRODUCT MANUAL
2-5
Installation and Setup
Installing a Rear I/O Module
923X Group Rear I/O Modules
Table 2-1 shows and describes the full assortment of Rear I/O Modules
specifically for use with the 932X group.
Note:
• Rear I/O Modules equipped with 3-wire Phoenix connectors are supplied
with removable screw terminal block adapters. For clarity, the adapters are
omitted in the drawings below.
• Rear I/O Module part number indicates I/O module-to-card applicability
(e.g., “RM20-9323A” is suitable for use only with 9323 card).
• Rear I/O Modules with DOLBY META port provide RS-485 port usable for
Dolby metadata decoder output (where equipped with option +DEC) or
serial LTC I/O (where licensed for option +LTC).
Table 2-1
932X Rear I/O Modules
932X Rear I/O Module
Description
RM20-9323-A
Provides the following connections:
• HD/SD-SDI coaxial input (SDI IN)
• Two HD/SD-SDI reclocked input copies
(RCK OUT)
• Four AES I/O coaxial input/outputs (AES I/O 1 thru
AES I/O 4; I/O function of each connection is
user-configurable)
• Two buffered SDI coaxial outputs (SDI OUT)
Note: For AES I/O 1 thru AES I/O 4 on
RM20-9323-A Rear I/O Module to function as
inputs, AES I/O switches S11 – S14 must be
set to Input (factory default).
See Setting I/O Switches for AES I/O (1-4)
Ports (9321, 9323 Only) (p. 2-1) for more
information.