Asus RX3042H - Manual (Page 23)

RX3042H User's Manual Quick Start Guide
11
3 Quick Start Guide
This Quick Start Guide provides basic instructions for connecting
the RX3042H to a computer or a network and to the Internet.
• Part 1 provides instructions to set up the hardware.
• Part 2 describes how to configure Internet properties on your
computer(s).
• Part 3 shows you how to configure basic settings on the
RX3042H to get your LAN connected to the Internet.
After setting up and configuring the device, you can follow the
instructions on page 15 to verify that it is working properly.
This Quick Start Guide assumes that you have already established
ADSL or cable modem service with your Internet service provider
(ISP). These instructions provide a basic configuration that should
be compatible with your home or small office network setup. Refer
to the subsequent chapters for additional configuration instructions.
3.1 Part 1 — Connecting the Hardware
In Part 1, you connect the device to an ADSL or a cable modem
(which in turn is connected to a phone jack or a cable outlet), the
power outlet, and your computer or network.
Warning: Before you begin, turn the power off for all
devices. These include your computer(s), your LAN
hub/ switch (if applicable), and the RX3042H.
Figure 3.1 illustrates the hardware connections. Please follow the
steps that follow for specific instructions.
3.1.1 Step 1. Connect an ADSL or a cable modem
For the RX3042H: Connect one end of the Ethernet cable to the
port labeled WAN on the rear panel of the device. Connect the
other end to the Ethernet port on the ADSL or cable modem.