Asus RX3042H - Manual (Page 84)

Configuring Firewall RX3042H User's Manual
72
Field Description
NAT
None Select this option if you donʼt intend to use NAT in this
ACL rule.
IP Address Select this option to specify the IP address of the you
want the outgoing traffic to use as the source IP address.
Note this option is called.
Auto RX3042H automatically uses the IP address of the
interface that the traffic is to be forwarded as the source
IP address. It is recommended that you select this option
if NAT is to be used for out going traffic
Source
This option allows you to set the source network to which this rule
should apply. Use the drop-down list to select one of the following
options:
Any
This option allows you to apply this rule to all the
computers in the source network, such as those on the
Internet for the inbound traffic or all the computers in the
local network for outbound traffic.
IP Address This option allows you to specify an IP address on which
this rule will be applied.
IP Address Specify the appropriate network address
Subnet This option allows you to include all the computers that
are connected in an IP subnet. When this option is
selected, the following fields become available:
Field Description
Address Enter the appropriate IP address.
Mask Enter the corresponding subnet mask.
MAC Address This option allows you to specify a MAC address on
which this rule will be applied.
MAC Enter the desired MAC address.
Destination
This option allows you to set the destination network to which
this rule should apply. Use the drop-down list to select one of the
following options:
Any This option allows you to apply this rule to all the
computers in the local network for inbound traffic or any
computer in the Internet for outbound traffic.