Asus RX3042H - Manual (Page 25)

RX3042H User's Manual Quick Start Guide
13
You should verify that the LEDs are illuminated as indicated in Table 3.1.
Table 3.1 LED Indicators
This LED: ...should be:
POWER Solid green to indicate that the device is turned
on. If this light is not on, check if the AC adapter is
attached to the RX3042H and if it is plugged into a
power source.
LAN LEDs Solid green to indicate that the device can
communicate with your LAN or flashing when the
device is sending or receiving data to/from your
LAN computer(s).
WAN Solid green to indicate that the device has
successfully established a connection with your ISP
or flashing when the device is sending or receiving
data to/from the Internet.
If the LEDs illuminate as expected, the RX3042H is working properly.
3.2 Part 2 — Configuring Your Computers
Part 2 of the Quick Start Guide provides instructions for configuring the
network settings on your computers to work with the RX3042H.
3.2.1 Before you begin
By default, the RX3042H automatically assigns all required network
settings (e.g. IP address, DNS server IP address, default gateway
IP address) to your PCs. You need only to configure your PCs to
accept the network settings provided by the RX3042H.
Note: In some cases, you may want to configure
network settings manually to some or all of your
computers rather than allow the RX3042H to do so.
See “Assigning static IP addresses to your PCs” in
page 13 for instructions.
• If you have connected your PC via Ethernet to the RX3042H,
follow the instructions that correspond to the operating
system installed on your PC.
3.2.2 Windows® XP PCs: