Asus RX3042H - Manual (Page 90)

Configuring Firewall RX3042H User's Manual
78
9.6.1 Add a Self-Access Rule
To add a Self-Access rule, follow the instructions below:
1. Open the Self-Access Rule Configuration page by clicking
Firewall/NAT ->Self-Access ACL menu.
2. Select “ Add New” from the “ID” drop-down list.
3. Set desired action (Allow or Deny) from the “ Action” drop-down list.
4. Assign a priority for this rule by selecting a number from the
“ Move to” drop-down list. Note that the number indicates the
priority of the rule with 1 being the highest. Higher priority rules
will be examined prior to the lower priority rules by the firewall.
5. Make desired changes to any or all of the following fields:
source/destination IP, service, time and log. Please see Table 9.3
for explanation of these fields.
6. Click on the " Add" button to create the new Self-Access
rule. The new rule will then be displayed in the Existing Self-
Access ACL list table at the bottom half of the Self-Access ACL
configuration page.
Figure 9.7. Self-Access ACL Configuration Page