Asus RX3042H - Manual (Page 93)

RX3042H User's Manual Configuring Firewall
81
virtual server configuration.
Table 9.5. Virtual Server Configuration Parameters
Setting Description
ID
Add New Click on this option to add a new virtual server.
Number Select the ID of a virtual server from the drop-down list to
modify its settings.
Move to
This option allows you to set a priority for virtual server rule check. NAT
does the IP and/or port mapping based on the priority of the rules. Set a
priority by specifying a number for its position in the list of rules
1 (First) This number marks the highest priority.
Other
numbers
Select other numbers to indicate the priority you wish to
assign to the rule.
Destination IP
This option allows you to set the destination network to which this rule
should apply. Use the drop-down list to select one of the following options:
Any
IP Address Enter the IP address of the virtual server if the virtual
server has a known public IP address.
Interface Use the IP address of the selected interface as the
destination IP address. Available options are:
eth1 (WAN1)
eth2 (WAN2)
ppp1 (WAN1 – unnumbered)
ppp2 (WAN2 – unnumbered)
ppp3 (WAN1 – PPPoE 1)
ppp4 (WAN1 – PPPoE 2)
ppp5 (WAN2 – PPPoE 1)
ppp6 (WAN2 – PPPoE 2)
Service Select a service, from the drop-down list, to which this rule
should apply. If the desired service is not listed, click on
the Edit button to create a new service.
Redirect IP Enter the IP address of the computer (usually a server in
your LAN) that you want the incoming traffic to be directed.
For example, if IP address of the web server on your LAN
is 192.168.1.28, please enter 192.168.1.28 here.