Asus RX3042H - Manual (Page 33)

RX3042H User's Manual Quick Start Guide
21
If the LEDs do not illuminate as expected or the web page does not
display, see Appendix 12 for troubleshooting suggestions.
3.3.3 Default Router Settings
In addition to handling the DSL connection to your ISP, the
RX3042H can provide a variety of services to your network. The
device is pre-configured with default settings for use with a typical
home or small office network.
Table 3.2 lists some of the most important default settings; these
and other features are described fully in the subsequent chapters.
If you are familiar with network configuration settings, review the
settings in Table 3.2 to verify that they meet the needs of your
network. Follow the instructions to change them if necessary. If
you are unfamiliar with these settings, try using the device without
modification, or contact your ISP for assistance.
Before you modifying any settings, review Chapter 4 for general
information about accessing and using the Configuration Manager
program. We strongly recommend that you contact your ISP prior to
changing the default configuration.
Table 3.2 Default Settings Summary
Option Default
Setting
Explanation/Instruction
DHCP
(Dynamic Host
Configuration
Protocol)
DHCP server
enabled with
the following
pool of
addresses:
192.168.1.100
through
192.168.1.200
The RX3042H maintains a
pool of private IP addresses for
dynamic assignment to your LAN
computers. To use this service,
you must have set up your
computers to accept IP information
dynamically, as described in Part
2 of the Quick Start Guide. See
section 6.1 for an explanation of
the DHCP service.
LAN Port IP
Address
Static IP
address:
192.168.1.1
subnet mask:
255.255.255.0
This is the IP address of the
LAN port on the RX3042H. The
LAN port connects the device to
your Ethernet network. Typically,
you will not need to change this
address. See section 5.1 LAN
Configuration LAN IP Address
for instructions.