Asus RX3042H - Manual (Page 43)

RX3042H User's Manual Router Setup
31
5.2.2.1 WAN PPPoE Configuration Parameters
Table 5.2 describes the configuration parameters available for
PPPoE connection mode.
Table 5.2. WAN PPPoE Configuration Parameters
Setting Description
Link Select a port to configure. Available options are
WAN1, WAN2 or DMZ.
Connection
Mode
Select PPPoE from the connection mode drop-down list.
PPPoE
Session
Select the PPPoE session ID for this PPPoE
session. Note that only two simultaneous PPPoE
sessions are supported.
Enable Check or uncheck this box to activate or de-activate
this PPPoE session.
User
Name and
Password
Enter the username and password you use to log into
your ISP. (Note: this is different from the information you
used to log into Configuration Manager.)
Service
Name
Enter the service name provided by your ISP. Service
name is optional but may be required by some ISP.
AC Name Enter the access concentrator name provided by
your ISP. Access concentrator name is optional but
may be required by some ISPs.
IP Address If your ISP allows you to always obtain the same IP
address for your WAN, enter it here.
Primary /
Secondary
DNS
Server
IP address of the primary and/or secondary DNS
are optional as PPPoE will automatically detect the
DNS IP addresses configured at your ISP. However,
if there are other DNS servers you would rather use,
enter the IP addresses here.
MTU You may specify the maximum size of the transmitted
packet. For PPPoE, the range of MTU is from 546 to
1492. The default value is 1492.
Disconnect
after idle
(min.)
Enter the inactivity timeout period at which you want
to disconnect the Internet connection when there
is no traffic. A value of 0 means no activity time
out. Note that SNTP service may interfere with this
function if there are activities from the service.