Acer AB460 F1 - Manual (Page 311)

291
TACACS+ Server Configuration
Clicking the TACACS+ S ERVERS tab brings up the TACACS+ S ERVER
C
ONFIGURATION
page, which allows you to configure TACACS servers.
The parameters for this page are shown in the following table.
Retries This parameter determines the number of times the
switch searches the active TACACS server from the list
of servers maintained. The allowed values are between
1 to 100 .
Figure 4-181. TACACS+ Servers
Parameter Description
IP Address This parameter specifies the IP address of the TACACS
server.
Port Use this parameter to specify the TCP port for TACACS
protocol.
Parameter Description