Acer AB460 F1 - Manual (Page 448)

4 Networking Switch Modules 428
BGP
The BGP link allows you to configure the BGP protocol. Following are
the configuration parameters available to manage BGP through this
interface:
•
“BGP Basic Settings” on page 428
• “BGP Peer Configuration” on page 430
• “BGP MED Configuration” on page 431
• “Local Preference” on page 432
• “BGP Filter” on page 434
• “Route Aggregations” on page 435
• “Advanced BGP Configuration” on page 436
• “BGP Community Management” on page 438
BGP Basic Settings
Clicking the B
ASICS
tab brings up the BGP B
ASIC
S
ETTINGS
page. The
parameters for this page are shown in the following table.
Parameter Description
Status This parameter specifies the BGP admin status. Using
this, the protocol can be enabled/disabled in the
switch.