Acer AB460 F1 - Manual (Page 35)

15
Installing an enclosure:
1. Decide where you want to place the blade enclosure into the rack
(see "Rack Mounting Considerations" in the previous section).
2. Position the Enclosure Template at the front of the enclosure to
determine the locations of the screws for the enclosure rails (see
Figure 2-5).
Figure 2-5. Positioning the Enclosure Template
3. The two enclosure rail sections are screwed together to keep them
immobile during shipping. Release these screws just enough to
allow the rails to slide apart. Note the arrow on the rail, which
indicates the end that attaches to the front of the rack.
4. Slide the rails apart far enough to match the depth of the rack.
Position the rails with the template and secure the front of each to
the front of the rack with two flathead screws, then secure the
back of each rail to the rear of the rack with two flathead screws
(see Figure 2-6). Note that the rails are left/right specific and very
heavy.
Figure 2-6. Securing the Rails to the Rack