Acer AB460 F1 - Manual (Page 605)

585
PS/2 Mouse Boot Summary
Screen: PS/2 Mouse installed.
nnnn kB Extended RAM
Passed Where nnnn is the amount of RAM in kilobytes
successfully tested.
nnnn Cache SRAM Passed Where nnnn is the amount of system cache in
kilobytes successfully tested.
nnnn kB Shadow RAM
Passed Where nnnn is the amount of shadow RAM in
kilobytes successfully tested.
nnnn kB System RAM
Passed Where nnnn is the amount of system RAM in
kilobytes successfully tested.
One or more I2O Block
Storage Devices were
excluded from the Setup
Boot Menu There was not enough room in the IPL table to
display all installed I2O block-storage devices.
Operating system not
found Operating system cannot be located on either
drive A: or drive C:. Enter Setup and see if fixed
disk and drive A: are properly identified.
Parity Check 1 nnnn Parity error found in the system bus. BIOS
attempts to locate the address and display it on
the screen. If it cannot locate the address, it
displays ????. Parity is a method for checking
errors in binary data. A parity error indicates
that some data has been corrupted.
Parity Check 2 nnnn Parity error found in the I/O bus. BIOS attempts
to locate the address and display it on the
screen. If it cannot locate the address, it displays
????.
Press <F1> to resume,
<F2> to Setup, <F3> for
previous Displayed after any recoverable error message.
Press <F1> to start the boot process or <F2> to
enter Setup and change the settings. Press <F3>
to display the previous screen (usually an
initialization error of an
Option ROM , i.e., an
add-on card). Write down and follow the
information shown on the screen.
BIOS Message Description