Xylem CG 843 - Manual (Page 23)

Operation
91
Note
The current AutoRead measurement (with acceptance of
the current value) can be terminated at any time by pressing
<run/enter>.
4.2.2 Measuring the Redox voltage
The pH meter can measure the Redox voltage (mV) of a
solution when connected with a Redox electrode, e.g. Blue-
Line 31 Rx.
Note
Redox electrodes are not calibrated. However, you can
check Redox electrodes using a test solution.
1 Perform the preparatory activities according to sec-
tion 4.2.
2 Immerse the Redox electrode into the test sample.
3 Press the <pH> key repeatedly until U appears in the
status line. The Redox voltage (mV) of the sample
appears on the display.
4 Wait for a stable measured value.