Xylem CG 843 - Manual (Page 43)

Operation
111
Note
You can the cancel the transmission by pressing <pH> or
<run/enter>.
1 Select the parameter (e.g. date) by pressing <run/
enter>.
2 Press < ▲ > or < ▼ > repeatedly until the required date
appears on the display.
After approx. 2 s, the temperature of the displayed
measured value appears.
1 Press the <RCL> key repeatedly until Sto SEr ap-
pears on the display.
2 Press the <run/enter> key.
Sto CAL appears on the display . The calibration pro-
tocol is transmitted to the RS interface.
Following the calibration protocol, the complete con-
tents of the storage is transmitted to the RS interface.
Outputting to
RS interface