Xylem handylab pH LF 12 - Manual (Page 50)

Operation handylab pH/LF 12
50 ba75370e03 11/2009
As soon as all of the 500 storage locations are occupied, AutoStore is termi-
nated (Int 1 = OFF). If there are not enough storage locations available for
your measurements:
z Output and backup the data storage (see page 51) and
z Clear the memory (see page 56).
Note
The AutoStore function is interrupted if you start other functions, e.g. output
the data storage. After the function is finished, the AutoStore function is con-
tinued. By this, however, temporal gaps in the recording of the measured val-
ues will occur.
Switching off
AutoStore
Switch AutoStore off by:
z setting the save interval (Int 1) to OFF, or
z switching the measuring instrument off and then on again.
6 Set the required ID number with <
▲> <▼>.
7 Confirm with <RUN/ENTER>.
The measuring instrument switches to the last active measur-
ing mode and starts the measuring and saving procedure. Au-
toStore flashes on the display.
e r F
9 9 9 S 1
LoBat
Tref25
nLF
/ K %
RCL
Sal
°
AR
TP
C
M
m
% mg/l
cm
S/ cm
cm 1/
° F
ARng Cal Lin
Tref20
Sal TDS
mbar
O UpH
mV/pH
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Year
1
Store Auto
Ident