Alpha Technologies DSM3 for XM3 - Technical Manual - Manual (Page 30)

30 745-814-B11-001, Rev. C (03/2014)
4.8 Setting the I/O Controller via the Web Page
Access the I/O Environment page in the Advanced Configuration menu to adjust the settings for
the Tamper Switch and I/O Controller. The Tamper Switch polarity may be changed by clicking on the
preferred tamper switch polarity button. The I/O Controller section provides a user interface to select
the type of device that will be connected and monitored via the ENV connector of the Communications
Module. An example of such a device would be the battery heater mat controller.
Fig. 4-13, Advanced I/O Controller Status Screen
(data values shown for illustration purposes only)
4.0 Web Interface