AT&T SB67138 - Manual (Page 39)

33
Getting started
Mailbox setup (for general mailbox)
Notify alert
Use this feature to receive notification calls to any phone number you set
(such as a cellular phone or paging device) after a new message has been
recorded to the general mailbox. To receive notification calls, you must save
the number you wish to be notified at to the telephone base, and then set
the system to call this number after it finishes recording a message.
If the number called has caller ID service, there will be an indication of the
notification call. When you receive a notification call, you hear about 15
seconds of silence; then the call is ended. There is no message sent and the
call is only made once. If the call is not picked up within three rings, the
telephone base cancels the call. You may not receive the call if the number
you set is busy, not available or off during the call.
When the telephone is idle, press MENU
/ENTER
.
Press or to scroll to Mailbox setup. Press
MENU/
ENTER.
Press or to scroll to Notify alert. Press
MENU/
ENTER.
Set alert number:
Press
MENU/
ENTER again to select Alert call #.
Use the dial pad to enter the number (up to 32 digits)
of the cellular phone or paging device you want to be
notified.
Press REMOVE to backspace and delete a digit.
Press REP or SKIP to move the cursor to the left or right.
3. Press
MENU/
ENTER to save the setting and return to the previous menu.
There is a confirmation tone. To exit without making changes, press EXIT.
Turn alert on or off:
1. Press or to scroll to
Alert on/off. Press
MENU/
ENTER.
2. Press or to scroll to On or Off.
3. Press
MENU/
ENTER to save the setting and return to
the previous menu. There is a confirmation tone. To exit
without making changes, press
EXIT.
1.
2.
3.
1.
2.
•
•
Set access code
Call screening
Notify alert
Remaining space
>
Alert call #
Alert on/off
Calling alert # >
Alert on/off
:On
ENTER=Save