Brooks Instrument SLAMf Series - Manual (Page 17)

1-11
Section 1 - Introduction Installation and Operation Manual
X-TMF-SLAMf-MFC-eng
Part Number: 541B032AAG
April, 2013
Brooks ® Digital MFC's and MFM's
Certifications:
EMC Directive 89/336/EEC:
Per EN 61326
Enclosure: Type 4X / IP66
Ambient Temperature: 0 0 F > Tamb < 150 0 F, (0 0 C > Tamb < 65 0 C)
Hazardous Location Classification
United States and Canada - Non incendive
UL Listed: E73889 Volume 1, Section 25
UL Recognized: E73889 Volume 3, Section 4
Class I, Division 2, Groups A, B, C, D, F and G; T4
Class I, Zone 2, AEx nA II T4
Per ANSI/ISA 12.12.02 - 2003 and ANSI/UL 60079 - 15
Ex nA II T4
Per CSA - E79 - 15
Europe - ATEX Directive 94/9/EC - Non Sparking
KEMA 04ATEX1290X
II 3 G Ex nA II T4
II 3 D Ex tD A22 IP66 T 85 0 C
Per EN 60079-0: 2006; EN 60079-15: 2005:
EN 61241-0: 2006; EN 61241-1: 2004
IECEx-Non Sparking
KEM 08.0043X
Ex nA II T4
Ex tD IP66 T 85 0 C
Per IEC 60079-0: 20044; IEC 60079-15: 2005;
IEC 61241-0: 2004; IEC 61241-1: 2004
Instructions for Safe Use:
United States and Canada: A Class 2 Power Supply must be used.
ATEX and IECEx:
1. Provisions shall be made to prevent the rated voltage from being
exceeded by transient disturbances of more than 40%.
2. When the temperature under rated conditions exceeds 70 0 C at the
cable or conduit entry point, or 80 0 C at the branching point of the
conductors, the temperature specification of the selected cable shall be in
compliance with the actual measured temperature values.
Pressure Equipment Directive (97/23/EC)
See pressure Table 1-1 for further information.