Remote pipe mounting, Instrument wiring, Remote pipe mounting instrument wiring – Fluid Components International ST100 Series User Manual
Page 17
Advertising
ST100 Series Flow Meter
INSTALLATION
Fluid Components International LLC
13
Figure 8
Instrument Wiring
The flow transmitter can be powered by 85 – 265 Vac or 24 Vdc as specified in the instrument specification. The electronics cannot be configured to
switch between AC and DC power. For 220/265 Vac installations, a neutral reference circuit must be used.
All cable glands and conduit fittings must meet or exceed the area approval rating where the instrument is being installed.
The recommended instrument wiring routing is shown in figures 15 and 16.
Figure 15
Remote Pipe Mounting
Advertising