Fluid Components International ST100 Series - Manual (Page 21)

ST100 Series Flow Meter INSTALLATION
Fluid Components International LLC 17
HMI Display Navigation
The four IR sensors are used to navigate the HMI menu structure. The top and bottom sensors are used to scroll thru the menu selections. The right
sensor button is used to select and the left sensor button is used to return to the previous menu.
Enter/Select
Go Back / Escape
Scroll Up
Scroll Down
The setup menu allows the user to modify all process variable engineering units and the pipe dimensions. The basic functions that that are acces-
sible from the HMI menu are listed below:
1. Select Group (5 calibrations groups are available)
2. Acknowledge Alarms
3. Identify system faults
4. Set up:
Process variable engineering units
Pipe dimensions
Display orientation
Display contrast
5. SDcard remove and insert acknowledgment
HMI user password: E#C
The HMI provides access to some of the basic instrument setup features. This allows the user to make configuration changes to the instru-
ment without opening the enclosure lids. The ST100 PC interface configuration application provides an alternate method of configuring the
instrument. The PC configuration application is easy to use and is the recommended configuration tool when commissioning the instrument.
The ST100 configuration software instructions are provide in a supplement manual, FCI document number 06EN003403.
*ON display indicates PC Configuration Application is connected.