3 mechanical installation, 1 transmitter assembly, 2 mounting – Hach-Lange SI792(x) E HACH GLI 3700 series SI792(x) T 7MA2200 and 8398 series User Manual User Manual
Page 20: 1 wall mount, 2 panel or pipe mount (optional), 1 transmitter assembly 3.3.2 mounting, Installation
Installation
18
3.3 Mechanical installation
3.3.1
Transmitter assembly
Refer to
Figure 1
and the following instructions to assemble the
transmitter.
1. Insert the strain relief fittings in the holes of the back enclosure and
secure with the hex nuts (
Figure 2
).
2. Insert the conduit hardware or plugs in the back enclosure and
secure with the hex nuts.
3. Attach the display module to the back enclosure using the hinge pin.
3.3.2
Mounting
Refer to the following sections to mount the transmitter on a wall, panel
or pipe.
3.3.2.1 Wall mount
1. Use a punch to open the two wall-mount holes in the back enclosure
(
Figure 2
).
2. Drill holes in the wall suitable for the user-supplied mounting bolts.
3. Attach the back enclosure to the wall using two customer-supplied
bolts.
4. Insert the clear plastic plugs into the mounting holes.
3.3.2.2 Panel or pipe mount (optional)
Refer to
Figure 2
and the instructions supplied with the panel and pipe
mounting kits (see
).