Hach-Lange RTC103 N-Module - Manual (Page 45)

45
Parameterization and operation
4.6 Select sensors
1. To select sensors and their sequence for the RTC module,
press RTC > CONFIGURE > SELECT SENSOR.
Figure 4 Select sensor
2. Press ADD ( Figure 4 , item 3).
A selection list of all subscribers to the sc1000 network
opens.
SOFT-VERSION
Shows the software version of the RTC communication card
(YAB117) in the sc1000.
RTC MODE
Shows the installed RTC module variant, e.g. 1-channel closed-loop
control.
RTC VERSION Shows the software version of the RTC module.
4.5.3 2-Channel RTC103 N-Module VFD (Continued)
RTC MODULES / PROGNOSYS
RTC MODULES
RTC
1 ENTER — Saves the setting and returns to the
CONFIGURE menu. 4 DELETE — Removes a sensor from the selection.
2 CANCEL — Returns to the CONFIGURE menu without
saving. 5 UP/DOWN — Moves the sensors up or down.
3 ADD — Adds a new sensor to the selection.