ADC Campus-REX2 RS - Manual (Page 119)

Chapter 7 - Using the LCD for Configuration and Management
Campus-REX2 RS Interface Card User Manual 107
Setting Router Configuration
When the network protocol is set to router, you can view the parameters
indicated in the sections below. Parameters such as the LINE and LAN IP
must be configured through the terminal screens.
Viewing Line and LAN IP Addresses. Complete this section to view
the IP addresses. The addresses must be configured through the terminal
screens. The LCD navigation to get to this submenu was provided in the
section
“Accessing LCD REX2 Configuration” on page 104 .
1 Press Next until you select Router Configuration, then press Enter.
2 Press Next until you select Port IP Settings, then press Enter.
The LAN IP address is displayed. If you have not changed the IP address
through the terminal screens, then the default IP address of 192.168.1.1
is displayed.
3 Press Next to view the LAN subnet mask.
4 Press Next to view the LINE IP address.
5 Press Next to view the LINE subnet mask.
6 Press Escape to return to the Router Configuration menu.
Viewing RIP Configuration. Complete this section to view the
configured parameters for RIP. The LCD navigation to get to this submenu
was provided in the section
“Accessing LCD REX2 Configuration” on page
104 .
1 Press Next until you select Router Configuration, then press Enter.
2 Press Next until you select RIP Configuration, then press Enter.
3 Press Next to view the configured parameters for:
• LAN RIP Send
• LAN RIP Rcv (receive)
• LINE RIP Send
• LINE RIP Rcv (receive)
• RIP Host Route
• Poison reverse
• RIP 2 auth