ADC Campus-REX2 RS User Manual
Page 60
Chapter 3 - Configuring the REX2
48
Campus-REX2 RS Interface Card User Manual
3
To set the Line IP address and subnet mask, type
then press
.
At the prompt, enter the Line IP address and subnet mask for the
Campus-REX2 Line port.
Required format is nnn.nnn.nnn.nnn
Enter Line IP Address: 192.150.10.20
Enter Subnet Mask (<CR> only=default Mask
255.255.255.0): 255.255.255.0
This value is the Campus-REX2 WAN port IP address. The Line
IP address cannot be on the same subnet as the LAN port IP address.
4
To configure the default gateway, type
then press
. At the
prompt, enter the IP address of the default gateway through which the
Campus-REX2 forwards datagrams if it does not have a valid entry for
the destination in its routing table. The default value for this parameter is
0.0.0.0.
Required format is nnn.nnn.nnn.nnn
Enter Default Gateway: 192.150.10.50
This parameter provides the default gateway through which packets are
routed to the internet if the next hop IP address IP address cannot be
identified. You can also configure the default gateway in the static
routing table by entering a destination IP address of 0.0.0.0 with a subnet
mask of 0.0.0.0 and then enter the IP address for the default gateway.
5
Type
then press
to return to the Router Configuration screen
). (Typing
will return you to the Main Menu.)
6
If you are only changing IP addresses or Default Gateway parameters, go
to
“Saving the Router Configuration” on page 55
to save your changes.
2
ENTER
3
ENTER
R
ENTER
M