ADC Campus-REX2 RS User Manual
Page 62
Chapter 3 - Configuring the REX2
50
Campus-REX2 RS Interface Card User Manual
3
To configure RIP for the LAN and Line ports, do the following:
a
To select the version of RIP packets that will be received by the
LAN port, type
then press
. Repeat until the preferred RIP
version is selected:
•
None indicates that a RIP version is not selected.
•
RIP1 indicates that only RIPv1 packets will be received by the
LAN port.
•
RIP2 indicates that only RIPv2 packets will be received by the
LAN port.
•
Both indicates that both RIPv1 and RIPv2 packets will be
received by the LAN port.
b
To select the version of RIP packets that will be sent by the LAN
port, type
then press
. Repeat until the preferred RIP
version is selected:
•
None indicates that a RIP version is not selected.
•
RIP1 indicates that only RIPv1 packets will be sent by the LAN
port.
•
RIP2 indicates that RIPv2 multicast packets will be sent by the
LAN port.
•
RIP1c indicates the RIPv2 broadcast messages will be sent by
the LAN port.
c
To select the version of RIP packets that will be received by the Line
port, type
then press
. Repeat until the preferred RIP
version is selected:
•
None indicates that a RIP version is not selected.
•
RIP1 indicates that only RIPv1 packets will be received by the
Line port.
•
RIP2 indicates that only RIPv2 packets will be received by the
Line port.
•
Both indicates that both RIPv1 and RIPv2 packets will be
received by the Line port.
5
ENTER
6
ENTER
7
ENTER