Installing into a desktop unit, Md i-x md i pc hu b – ADC Campus-REX2 RS User Manual
Page 15
Chapter 1 - Installing and Accessing the REX2
Campus-REX2 RS Interface Card User Manual
3
Installing into a Desktop Unit
Install the Campus-REX2 interface card into a Campus-RS or Campus-HRS
desktop unit before you install the desktop unit (install power and HDSL
cables). Install the Campus-RS desktop unit using the instructions in the
Campus-RS Desktop Unit User Manual.
1
Ensure that the desktop unit is not connected to power.
2
Slide the Campus-REX2 into the guide rails in the rear of the
desktop unit.
3
Gently press the card into place until it is seated firmly in the mating
connector.
4
Secure the card in place using the two captive screws.
5
Complete the desktop unit installation using the Campus-RS Desktop
Unit User Manual.
Ensure power is off to the desktop unit before you install the
Campus-REX2. Installing the card with the power on may
cause damage to the desktop unit, the card, or to both.
CAMPUS-RS
CO
NS
OL
E
LIN
E
Guide rail
Campus-REX2 RS
Interface card
Campus-RS Desktop Unit chassis
120
VA
C@60Hz
or 220
VA
C@50Hz
.2A Max
REX2 Router
Lin
k/A
cti
vit
y
10
B
as
e-T
10
0 B
as
e-T
x
MD
I-X
MD
I
PC
HU
B