Controlled Products Systems Group CSL24VH - Manual (Page 12)

10
PREPARATION
Gate must be constructed and installed according to ASTM F2200 standards (refer to page 4). Gate must fit specifications of operator (refer to specifications).
GATE
SITE PREPARATION
Check the national and local building codes BEFORE installation.
Install catch rollers with safety covers
on the side of a post or wall with a
minimal distance of half an inch
between the rollers and gate.
DO NOT use a gate catch post.
Because the coasting distance may vary due to
changes in temperature, it is NOT recommended
to install a stop or catch post in front of the
gate's path. To do so will cause the gate to hit
the post in certain instances.
SAFETY CATCH ROLLERS