Controlled Products Systems Group CSL24VH - Manual (Page 17)

15
POWER WIRING
WIRING
POWER WIRING
This operator can be wired for either 120 Vac or 240 Vac or a solar
panel (not provided). Follow the directions according to your application.
For dual gate applications, power will have to be connected to each
operator. Main power supply and control wiring MUST be run in
separate conduits.
240 VAC ONLY
If using the 240 Vac option a heater cannot be used. The accessory outlet is disabled
and cannot be used with the 240 Vac option.
1
Remove the outlet housing from the electrical box by removing the screws
(2).
2
Pull the outlet housing out and locate the power wiring connector on the EMI
board.
3
Unplug the power wiring connector from the 120 Vac socket (factory default
location) and plug it into the 240 Vac socket.
4
Replace the outlet housing by securing with the screws. The operator is now
set for 240 Vac operation.
Outlet Housing
Power Wiring Connector
(120 Vac Socket, factory default)
240 Vac Socket
NUMBER OF CYCLES PER DAY
Slide Gate Installation (16 ft. 1000 lb. gate)
Accessories Single Gate
Solenoid Lock 50 mA 100 mA 300 mA
7AH Batteries
(standard)
33AH Batteries
(optional)
TRANSFORMER
POWERED
Continuous Continuous
✔ Continuous Continuous
✔ Continuous Continuous
✔ Continuous Continuous
✔ Continuous Continuous
BATTERY
POWERED
100 275
✔ 35 230
✔ 45 270
✔ 45 270
✔ 40 260
AMERICAN WIRE
GAUGE (AWG)
MAXIMUM WIRE
LENGTH (120 VAC)
MAXIMUM WIRE
LENGTH (240 VAC)
14 130 feet 260 feet
12 205 feet 410 feet
10 325 feet 650 feet
8 520 feet 1040 feet
6 825 feet 1650 feet
4 1312 feet 2624 feet
AC POWER SWITCH
The AC Power switch on the operator will turn the incoming 120/240 Vac power ON
or OFF. The operator's AC Power switch ONLY turns off AC power to the control board
and DOES NOT turn off battery power.
AC Power Switch
EMI Board
NOTE: Use copper conductors ONLY.