Controlled Products Systems Group CSL24VH - Manual (Page 16)

14
EARTH GROUND ROD
Use the proper earth ground rod for your local area. The ground wire must be a
single, whole piece of wire. Never splice two wires for the ground wire. If you should
cut the ground wire too short, break it, or destroy its integrity, replace it with a single
wire length.
1
Install the earth ground rod within 3 feet of the operator.
2
Run wire from the earth ground rod to the operator.
NOTE: If the operator is not grounded properly the range of the remote controls will
be reduced.
WIRE THE ENTRAPMENT PROTECTION DEVICES + EARTH GROUND ROD
WIRING
To prevent SERIOUS INJURY or DEATH from a moving gate:
• Entrapment protection devices MUST be installed to protect anyone who may
come near a moving gate.
• Locate entrapment protection devices to protect in BOTH the open and close
gate cycles.
• Locate entrapment protection devices to protect between moving gate and
RIGID objects, such as posts or walls.
Connect the entrapment protection device to the EYES EDGE terminal on the
control board. These inputs are for pulsed photoelectric sensors and dry contact
edges.
• Close Photoelectric Sensor Entrapment Protection: Connect wires from the
photoelectric sensors to the Inputs on the CLOSE EYES/INTERRUPT terminal.
• Close Edge Entrapment Protection: Connect wires from the entrapment
protection device to the Inputs on the CLOSE EDGE terminal.
• Open Entrapment Protection: Connect wires from the entrapment protection
device to the Inputs on the OPEN EYES/EDGE terminal.
NOTE: Refer to the “Accessory Features on the Control Board” section on
page 27.
1
WIRE THE ENTRAPMENT PROTECTION DEVICES
Entrapment protection devices are required. Refer to page 5 for more information regarding application.
TO ERASE LEARNED MONITORED PHOTOELECTRIC
SENSORS
1
Remove the photoelectric sensor wires from the terminal block.
2
Press the SET OPEN and SET CLOSE buttons simultaneously until the SET OPEN
and SET CLOSE LEDs turn on.
3
Press both SET OPEN and SET CLOSE buttons again to turn off the SET OPEN
and SET CLOSE LEDs.
NOTE: For dual gate applications repeat the steps above on the other operator.
Check national and local
codes for proper depth
To Operator
ALARM RESET
1